Bathroom tiling in Bali

Showers, wet rooms and family bathrooms tiled the way Bali's humidity demands: membrane under the whole wet zone, walls and floors set straight, the fall to the drain checked with a level before the grout goes in. Labour from IDR 150,000/m² for walls and IDR 170,000/m² for floors, free site visit and a fixed quote first.

Send bathroom size and photos

Bathroom tiling that starts with the membrane, not the tile

Every bathroom tiling job we take in Bali starts under the tile, not on it. A wet room without a sealed membrane feeds moisture into the slab from the first month of showers; the adhesive bond decays quietly and tiles begin letting go within a year. So our sequence never changes: seal the wet zone, set walls and floors, slope the floor so water actually reaches the drain, grout cleanly, and finish every junction with silicone instead of rigid grout.

Free site visit and fixed quote — all Bali areas

We come to the property, check the slab, the existing falls and any leak marks on the ceiling below, measure and put the total in writing before any work starts. The visit costs nothing and commits you to nothing. We work in Canggu, Seminyak, Kuta and Legian, Denpasar, Sanur, Jimbaran, Nusa Dua, Uluwatu and Ubud at the same rates, with no travel surcharge.

How we tile a bathroom — step by step

1. Waterproofing first

Before a single tile goes down, we apply a proper waterproofing membrane across the floor, up the walls in the shower zone and into every corner and pipe penetration. In Bali's humidity this is the step that decides whether the bathroom lasts ten years or starts leaking into the room below within twelve months. Most failed Bali bathrooms we're called to repair simply skipped it.

2. Substrate and slope

We level the substrate and form the correct fall toward the drain — a gentle, consistent slope so water never pools. Get this wrong and you have standing water, staining and a slip hazard. We check the fall with a level before tiling, not after.

3. Setting walls and floors

Walls and floors are laid with the correct adhesive and full coverage — no dot-and-dab that leaves hollow tiles. We plan the layout from the centre and the key sightlines so cut tiles land in discreet places, not as thin slivers beside the door.

4. Grout and silicone

Clean, even grout lines, then flexible silicone in every internal corner and at the floor-to-wall junction where rigid grout would crack. We finish the wet area so it reads tidy and performs properly.

Common Problems We Fix

The bathrooms we're called to fix in Bali almost always failed for one of a few reasons: no waterproofing membrane, a floor that slopes the wrong way or not at all, hollow tiles from poor adhesive coverage, or rigid grout used in corners that should have been siliconed. We address every one of these on a new install — and diagnose which one caused the problem before any repair.

Bathroom tiling prices in Bali

WorkLabour (IDR/m²)Notes
Bathroom wall tilingfrom 150,000Membrane applied in the shower zone
Bathroom floor tilingfrom 170,000Drain fall and membrane
Natural stone in wet areasfrom 210,000Honed finish, sealed
Regrouting a bathroomfrom 140,000Rake out old grout, regrout

Labour prices per m²; tiles, adhesive, grout and membrane materials are quoted separately. Epoxy grout for showers is available and priced with the job. A leaking bathroom is quoted after we have traced the leak — sometimes a regrout is enough, more often the wet area has to be stripped and re-membraned. Why the membrane matters is explained in what tilers check before tiling; all rates are on the tiling price list.

Send a photo of the bathroom. One wide photo, the floor around the drain and any stain on the ceiling below, plus the rough size. We reply with the likely scope and a labour estimate, then confirm at a free visit.
Get a bathroom quote

Related services

We also handle floor tiling, tile repair and regrouting, natural stone installation and pool tiling. All across Bali, same rates, no travel surcharge.

Book a free site visit
How long does bathroom tiling take in Bali?
A standard bathroom of 4–6m² takes 2–3 days including waterproofing, setting and grouting, plus curing time before use. We give a firm timeline before starting.
Do you waterproof before tiling?
Always. A waterproofing membrane goes down before any tile in every wet area we install. It is the single most important step for a Bali bathroom and we never skip it.
Can you fix a leaking bathroom that's already tiled?
Yes — we trace the cause first, usually a failed or absent membrane, then strip back the affected wet area, waterproof correctly and re-tile. See our tile repair service.
Do you supply the tiles?
Both options work. We can source tiles at trade prices from Bali suppliers, or install tiles you've already chosen. Tell us which you prefer.
Large-format marble-look tiles installed in a luxury Bali villa bathroom
WhatsApp Us
Get a tiling quote Send the area in m², tile type and photos — we reply with a price range and confirm it at a free site visit. Chat on WhatsApp →